Legal tyre tread depth uk

Are tyres legal depth? UK tyre law states that 1. Learn how to carry out tyre safety checks and when you should replace worn tyres. The legal limit for minimum depth of the tread on your tyres is 1. For safety reasons it is recommended that you replace your tyres before the legal limit is reached.

Many vehicle manufacturers recommend replacing at millimetres, as below this. Tyre tread depth has to be above 1. This must be the case for the middle three quarters of the tyre. There are three ways to check this: How to check tyre tread depth – the 20p test. Remember: - Check your tread depth on all four tyres - Check the inner, centre and outer.

However, this is just the minimum. Some believe that to be truly safe, you should aim for a minimum tread depth of 3mm.

A brand new car tyre starts off with approximately 8mm of tread. So what is the legal tyre tread depth ? In the UK and Europe, the legal minimum tread depth for cars in the UK is 1. What if my tread depth is below this? Tyre wear on outside edge – is it legal ? Tread must be a certain depth depending on the type of vehicle: cars, light vans and light trailers - 1. The minimum legal tread depth is 1. Driving with worn tyres is not only a serious safety risk, but a costly one too. Tyre pressure - your tyres should be inflated according to the manufacturer’s recommendations and around the circumference of the tyre. The law requires a minimum tread depth of 1. You can check the tyre ’s tread depth with a tyre tread depth gauge, but for a. Drivers will also be issued three penalty points for each tyre which does not meet legal tread depth rules.

Tyre safety is a matter of life and death. As penalties are issued based on each tyre , road users could see penalties rise to £. UK Tyre Law Tread depth. In wet weather tyre tread grooves help to remove water from the contact patch between your tyres and the road surface meaning your car can brake, steer and accelerate properly.

Without adequate tread. The best way to check you tread depth is to buy a tread depth gauge. The gauge will give you the exact amount of tread remaining and will a lot more accurate.

The most accurate is the digital type. Another quick method to measure your tyre tread is the ‘20p test’. This involves inserting a pence coin. The recommended tyre tread depth. Tyre and safety experts believe the 1. According to the law , the tyre tread depth must be at least 1. The tread on a tyre helps to disperse.

Research shows that it can take a car with 1. If the tread measurement is between 1. Legal limit UK ) around three quarters of the tyre , so bear this in mind when your measuring. Using a tread depth gauge If you are using a tread depth gauge, you place it on the surface of the tyre and push the end down and “A needle” will stick down into one of the tyre grooves and you’ll be able to get the depth reading. By law , tyre tread depth in the UK must never be less than 1. Many professionals believe that this is too slim a margin because tyre performance noticeably deteriorates well before they reach that point. That means it will brake to standstill metres.

So, in total, you could face a £10bill. Fortunately the points do not add up in the same way as the fine does and you would only receive three penalty points for the offence, irrespetive of how many tyres you were penalsied for. For motorcycles up to 50cc the law requires that all the grooves of the original tread pattern must be clearly visible.